NOTE: Your new AMC-IP Board may already have a license installed and an Autoload (Cold Start) may destroy the license. Always copy and paste the license into a document and save it for future use.
Basic Quick Start Station and System Programming
Note: A software license must be purchased to enable Networking, IP Substations and IP Masters, Gateways, SIP Stations and SIP Trunking. The AMC board MAC address is required to enable the license for each cabinet in an existing system, specifying how many of each type belongs to each MAC address.
Exchange
Startup
AlphaCom
E Hardware
Installation
Manual and System Management
AlphaCom
IP Basics
AlphaWeb
Network
Design Guide for AlphaCom VoIP
AlphaCom
VoIP Deployment
IPMux
compared to AMC-VoIP Bandwidth Requirements
AlphaCom
Multimodule on IP
AMC-VoIP
Getting Started
AlphaNet
over IP
IP
Routing Table in AlphaCom
IP
Substation Quick Start
IP
Substation Connections
IP
Substation Exchange Programming
IP
Substation Programming
IP
Master Station Configuration
IP
Master Station Basic Programming
IP
Master Station Kit and Connections
Getting
Started with SIP Phones
VoIP
SIP Gateway Manual
AlphaCom
E MPC Serial Data over IP
AlphaCom
E Ethernet to Serial Data Port Conversion
EDO
Programming Examples, sending EDO to another Node
AlphaCom
E Linux Console
AlphaCom
E TST Console
AlphaCom
E7 to 1386 Board
AlphaCom
E20 to 1386 Board
Installation Tips and Help How to program features, functions and trouble shooting. Some of the screens are based on the older non IP exchanges, so they look different but the functions are the same.
AMC Upgrade Files Call Zenitel Technical Support before you use this upgrade. Depending on your current configuration there may be many things to consider which may be difficult to recover from if you are not properly prepared.
IP Station Upgrade files Use to upgrade IP Stations. Instructions included. No installation.